Step 3: Deploy an Application

This section describes how to deploy an application on a BMS.

Install and Start Nginx

  1. Run the yum install nginx command to install Nginx and enter y as prompted.

    If the information shown in the following figure is displayed, Nginx is installed successfully.

  2. Enter systemctl start nginx.service to start Nginx.

    This command applies to CentOS 7.4 64-bit, which is used as an example.

  3. Enter wget http://127.0.0.1 to test Nginx.

Access the Default Web Page

Open a browser and enter http://BMS EIP in the address box. If the Nginx welcome page is displayed, Nginx is installed successfully.

Parent topic: Purchasing and Logging In to a Linux BMS